Reader Angela loved the vintage Amerock starburst backplates that Kate used on her bathroom vanity. So when she needed hardware for her kitchen cabinets, Angela wanted starbursts. Angela found them on Ebay, but at $28 each it would have cost nearly $1,000 for just the 34 backplates she needed. Instead of giving up, Angela got creative — and made an army of sparkly aqua acrylic copies from one Amerock original.
I really wanted atomic starburst backplates in my kitchen, but good grief they were expensive. I didn’t want the Rejuvenation Hardware version with four measly points, I wanted a vintage atomic with eight points! I found a whole hoard of new old stock on eBay, but ouch! $28 each? I needed 34 of them!
So, I purchased one of the eBay versions and got to work. I made molds with Easymold Silicone Putty
. (affiliate link)
.
Then, I cast the backplates using Craft Casting Clear Epoxy
(affiliate link). It took quite a bit of trial and error as the color I was trying to achieve was teal … not blue, not green, not turquoise, teal! I was trying to match the original tile sizzle stick in my kitchen’s backsplash. I started by practicing with colors I didn’t care for, with the most inexpensive craft glitter, then went into the teal attempts. By the time I was done, I had more than 100 extras! Did I mention I am obsessed with atomic starbursts? Yeah.
To get matching knobs, I purchased very inexpensive ceramic dead stock from a junk shop near my home, 0.33¢ each. I coated the knobs with the matching glitter mix, then with numerous coats of clear acrylic.
Long story short, the knobs and backplates came out great. And, they’ve been up in my kitchen for about 6 months with no issues on durability.
Two bonuses:
I traded all of the extra knobs and backplates with my favorite MCM second-hand shop owner. I got a fabulous floor lamp … with starbursts on it! He’s using my leftovers to googie up his finds.
I was also able to fix the knob on my yellow Deluxe DeVille model O’Keefe & Merritt stove I bought off Craigslist from L.A. I couldn’t find another knob anywhere. Apparently, the DeVille model was only made for a few years, so I:
- Found an old knob with the same shaft
- Removed every piece of the shaft from the knob I wanted to keep
- Broke apart the replacement knob and sawed out the shaft
- Glued the shaft on with the right stuff and really let it dry (like a week)
- Filled the inside of the knob with acrylic to support the glued-in shaft
So far, it’s working great!
NOTE: The acrylic is really sticky! Keep it in a safe place, away from foofy dog tails, while it’s drying!
As the fellow owner of a dog with a ‘foofy’ tail, I agree — keeping curious pups away from sticky substances — like wet paint or uncured acrylic — is a must. Wow — way to be resourceful Angela! Mega thanks for sharing your tips and tricks with us.
Barb S. says
Genius!!! My mind is crankin’ away here!! Thanks for sharing!
Ahem, so…. where is the picture of the starburst lamp 😀
Dan D says
Super cool! I love the way you think. Desperation is a great motivator for me as well, especially when I really want something to work as I envisioned it.
Diane Vallere says
This is such a cool idea with so many possibilities! The mind reels.
Thanks for sharing!
Debra says
Simply fantastic!!! I’m so jealous (in a good way) of her get in there crafty courage!! I think I’ll put my toes in the water & try it for our mid-century ranch!! Thanks for sharing!!
Kirsten says
Another way to accomplish this—if you have access to one— is to use a 3D printer.